Regardless of the age of your evaporative cooler, you may be noticing lately that it is not functioning the way it used to. If your cooler has been working overtime during the summer, it may want to clock out earlier than usual. That said, before digging into the details, remember that all things related to residential evaporative air conditioning are handled better by licensed and trusted professionals. This means that outsourcing the service will be the best call to make if unsure about how to proceed.
Keeping your swamp cooler under 94 degrees can generally promise a long-lasting piece of equipment. However, when your cooler gets exposed to a temperature about 94 degrees, it might suddenly stop working. This is because the pump within your evaporative cooler cannot moisten the pads enough to cool the house down. Instead, you end up with dried-out pads and an even more dried-out home.
You can prevent yourself a lot of headaches and heat strokes by applying these simple DIY tricks to hack your evaporative cooler into like-new condition. Read the steps below to ensure that your cooler will stay running strong all summer long!
Lock That Power Out!
One of the quickest things you can do to help restore your cooler into like-new condition is to shut down your power, and then lock it out. Turn it off using the power switch. You can even put some duct tape over it to make sure it is fully switched off, and that nobody can tamper with it.
Unplug the fan of your cooler’s motor to ensure that absolutely nothing will turn back on, not even by mistake. Plus, this gives you a bit more safety.
Add More Tubes!
During your evaporative cooler installation, there were likely 8 tubes installed as part of the assembly process. This new DIY life hack offers a way to overclock your evaporative cooler by 50%.
Want to hear it?
Simply add one more tube on each side, for a total of four more tubes! This brings your grand total of secondary distribution array tubes up to 12. You’ll have to temporarily remove the spider to install these extra tubes, but the results will be far worth it.
Change Out the Blue Pads
The blue pads that came with the installation of your evaporative cooler do not do a very good job at lasting a long time. In fact, they hardly act as sponges at all. It is difficult to get them to absorb the right amount of water, and they provide very little cooling benefits.
Thankfully, there’s a cheap way to replace these pads with something that proves to be far more effective:
Replace the pads with aspen pads.
That’s right, aspen!
This natural, woody product is a great absorbent material, and they are cheap to boot. You can grab yourself a handful of aspen sponge pads and re-insert these into your evaporative cooler. It is great for absorbing water, which can dramatically cool down your home. Just keep an eye out for when you have to clean them at the end of the year.
With these fast and easy DIY tricks to hack your evaporative cooler into like-new condition, you can guarantee that you will stay cool all summer long. Switching the power off during repairs is a great way to reset the cooler’s system and get all things on board and working again. Changing out the blue pads for something more durable and absorbent will help to create a better cooling effect. By adding more tubes, you are making the air distribution process much easier for your cooling system. Take advantage of the cooler weather to fix up your cooler and get prepared for next summer. When temperatures blaze, you will definitely remember these life hacks! Utilize these ideas, and your evaporative cooler will be working like a pro in no time!