Installing a hot tub in your home or your back yard is a great addition to your home. If you decide to sell your house at some point, it can significantly increase your asking price. However, installing a hot tub is not exactly cheap.
That’s why the manufacturers, retailers, and owners of hot tubs try to find ways to make hot tubs operational and functional for as long as possible. If you want your hot tub to serve you for a long time without a hitch, you should try to follow these maintenance tips.
Clean Your Hot Tub Cover
The hot tubs which are installed outside usually come with a cover which is supposed to protect the hot tub from the elements and the debris when it is not being used. However, these covers typically don’t get much attention from the hot tub owners.
This is the main reason why some of these covers start to develop an unpleasant musty odor. Fortunately, it is fairly easy to prevent this from happening. All you need is a solution of one part bleach and 9 parts water. Wipe the cover and then wash down the solution from the cover. Repeat that as necessary, at least once in three months.
Your Filters Need Maintenance
A clean hot tub is a long-lasting hot tub. One of the most important parts of the hot tub’s cleanliness are water filters. They remove any debris and dirt from your water, making sure that only clean water is recirculated into the hot tub.
There are products you can buy from your hot tub vendor which are fairly easy to use and are safe to be used by anyone. Just be sure that you are using the right amounts. You can learn more about that here https://aquaparadiseca.com/chemical-management/.
Check for Leaks Frequently
Barring physical damage to your hot tub, the most likely place where it can spring a leak is around the union fittings. These are located next to the water pump, and can become loose over time. If you notice that they are becoming a bit loose, you should tighten them manually. Do not use a wrench, since that can damage them and only exacerbate the problem.
The Bearings on the Motor
The whole point of a hot tub is to have water jetting and swirling around you. Not only is it pleasant, it is also known to have therapeutic properties as well. However, none of this would be possible without the electric motor which powers your hot tub.
You can see the telltale signs of potential future damage if your motor starts making more noise than usual without any additional stress. The bearings of the motor need to be checked every three to six months to ensure that everything runs smoothly for the foreseeable future.
Water Jets
The water jets direct the stream of high pressure water towards you to give you the massage treatment that you expect from a hot tub. If you find that the strength of the jets has decreased significantly, or they don’t work at all, there may be a simple solution. Perhaps all you need to do is twist the jets to allow the water to flow freely, or you may need to clean the jets.
However, if you have recently refilled your hot tub, there may be an air pocket obstructing proper air flow. Even though it may sound problematic, it is fairly easy to fix. All you need to do is loosen a fitting on your water pump. This will allow the air to leave the system, and you will have your jets up and running in no time.
Hot tubs require some maintenance, but they offer so much in return, and if you treat them right, they will give you many hours of fun and relaxation.
